Home > News > Content
Select The Outdoor LED Light To Pay Attention To The Details
Oct 10, 2017

We should pay attention to these places when we choose Outdoor LED Light. 1, poles main bar according to the drawings, galvanized square tube, wall thickness 3.5mm. Light source power: LED30W.

2, the poles part of the whole full welding, welding uniform and solid, the welding quality to meet the requirements, no impact strength of the cracks, slag, welding tumor, burn through, crater, no wrinkles and interruption and other defects.

3, the allowable deviation of the poles should meet the following specifications: ① length allows the deviation of the length of ± 0.5%; ② shaft straightness allowable error <1 ‰; ③ shaft cross-section diameter, diagonal or margin Allow the deviation should be ± 1%; ④ lamp arm elevation tolerance should be ± 1%.

Because Outdoor LED Light work environment are outdoors, wind and rain, so the Outdoor LED Light of the material is best to waterproof, put the corrosion. LED poles with anti-corrosion surface using hot-dip zinc spray treatment, corrosion quality in line with the provisions of which the average thickness of hot-dip zinc layer is not less than 85μm, LED poles should be used high-quality outdoor pure polyester plastic powder, the average thickness ≥ 100μm , Spray layer uniform, complete, smooth surface, its adhesion to meet the relevant standards.

LED poles below the door and the poles parallel to the poles parallel to the ground 400mm high open 320mm × 120mm access door, door welding terminal; door and door cover the edge of smooth, door and door hole assembly and door clearance Not more than 2mm, the door is interchangeable, and has an effective and reliable anti-theft measures.